WaterChef U9000 Manuel d'utilisateur télécharger pdf (Page 12)

www.waterchef.com

REPLACING THE FILTER CARTRIDGE

6. Make certain O-Ring is still seated on Lid Assembly. Place Lid

Assembly onto Filter Housing, and place Clamp around Lid

Assembly and Filter Housing. Tighten Knob on Clamp securely.

7. Place Filter Housing into Base. Insert Blue Tubing end into Blue

Outlet Connector and Red Tubing end into Red Inlet Connector

on Lid Assembly. Re-position System under your sink. (g. X)

8. Remove Battery Shuttle from Intelligent Monitor

™

and discard.

9. Insert new Battery Shuttle (included with Filter Cartridge)

into Intelligent Monitor

™

. (g. Y) The LED Indicators located on

the System Faucet will ash GREEN, YELLOW and RED three

times. This resets the rated capacity counter to zero gallons.

Do NOT remove Battery Shuttle until it is time to replace the

Filter Cartridge. Removing Battery Shuttle prematurely may

result in a loss of data.

10. Slowly turn your cold water supply “ON” and check for leaks.

11. Turn System Faucet “ON”. Water will begin to ll the Filter Housing.

Once water begins to ow from the System Faucet, the GREEN

LED Indicator will begin ashing to indicate peak operational

performance. Check to see that all hose, clamp and housing

connections are tight and do not leak.

12. Allow System to ush into sink for 15 minutes. This removes

any ne, black carbon particles left over from the manufacturing

process, expels trapped air and conditions the Filter Cartridge for

normal use. (This water may be used to water plants.)

New Battery

Shuttle

IMPORTANT

Repeat ﬂushing procedure each time a new Filter Cartridge is installed.

Blue Tubing from

Intelligent Monitor

™

Red Tubing from

3/8” T-Valve

Blue Tubing

Red Tubing

Blue Outlet Connector

Red Inlet Connector

Intelligent

Monitor

™

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

WaterChef U9000 Manuel d'utilisateur Page 12

Commentaires sur ces manuels