WaterChef U9000 Manuel d'utilisateur télécharger pdf (Page 8)

www.waterchef.com

SETUP & INSTALLATION

1. Slide the LED Faucet Ring up Faucet Tubing and onto Faucet

Stem. Next, insert Cable through hole in sink, followed by Faucet

Tubing and Faucet Stem (be careful not to crimp the Cable). (g. J)

2. From under the sink, guide Cable through the hole in the Spacer

(small side up). Next, slide Cable into the small notched area of

the Spacer hole. Insert the Faucet Tubing through the main area

of the Spacer hole and guide Spacer onto Faucet Stem. Thread

Wing Nut onto Faucet Stem and hand tighten. (g. K)

Faucet Stem

Blue Tubing

Spacer

Wing Nut

LED Faucet Ring

Cable

Cable Notch

Sink Cross-Section

System Faucet

NOTE

Final Faucet positioning may require two people when tightening the Wing Nut.

Be sure Cable remains in the notched area of Spacer hole as you slide the Faucet

Tubing and Stem through the Spacer to avoid damaging the Cable.

Faucet Installation:

IMPORTANT

TYPICAL UNDER-SINK INSTALLATION

Designer

Faucet

Monitor

Housing

RED Tubing

T-Valve

BLUE Tubing

Cable

HOT COLD

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

WaterChef U9000 Manuel d'utilisateur Page 8